PE electrofusion pipe fittings production standards and installation matters needing attention

  For our PE electrofusion fittings, the production has its own standards, which are the technical specifications and judgement guidelines for the manufacturing and testing of the products: technical specifications, test methods and judgement criteria, respectively.

   The design of PE electrofusion fittings ensures that when the fittings are assembled with pipes or other fittings, the resistance wires or seals cannot be displaced, which is the design standard of electrofusion fittings.

   In the installation of PE electrofusion fittings there are several aspects that need attention, this needs special reminders, I hope you can do as required:

   First of all vertical cutting of the pipe, the socket to the electrofusion fittings of the pipe position with a scraper to remove the surface oxide layer; again in accordance with the socket depth of the electrofusion fittings with a marker pen on the surface of the pipe to do a good job of marking the line. It is also necessary to insert the pipe into the electrofusion fittings until the depth of the marking line, after the installation of the axis of the pipe and the electrofusion fittings coincide. Finally, the pipe and fittings are fixed by clamps to prevent misalignment and loosening during welding.